I just recently acquired a Proficiency kit for my Marq6 with Tadao Ryujin, I have it set up and working. Something seems "off"...
LPR ~ 55psi
HPR ~ 225psi
Am I doing something not right here?
I have tried setting hpr lower, lpr lower, dwell lower in various combinations... nothing seems to work much better. From all the settings I have found everyone seems able to run lower HPR and lower dwell... some people seem to have a lower lpr too.
DO NOT TELL ME TO READ THE STICKIES. I HAVE READ THEM 142598745 TIMES.
It's only bad if you can't get it higher. If your field allows a higher velocity than raise it. One of my local fields has a limit of 280 fps for walk-on so 275 fps is ideal if it can be maintained consistently.
__________________ "I'm willing to admit that I may not always be right, but I am never wrong."-Samuel Goldwyn
Minutes from Hillary Clinton's post-election powwow w/ Lucifer: HRC: "Master, I don't understand... You said that I would win the election..." Prince of Darkness, The: "And YOU said that you had a soul..." FLIRG: *cackles disturbingly* /Meeting
Last edited by AlmightyRuler : 08-10-2008 at 06:38 PM.
thanks guys. I am going to try lpr of 65... I cant get more than 275fps right now, our field allows 300... I suppose I could try to up the hpr a bit more, however, I dont really know what the noids max is, dont really want to push it too hard.
My Closer settings with Proficience Engine now are
LPR - 70 psi
HPR - 212 psi
dwell - 8 (Tadao Ryujin)
I just installed it and it seems quite inconsistent (or probably paintballs were not so good) and velocity was about 290 fps
With LPR 50 psi I couldn't get velocity more than 230 fps
My closer settings with the new engine were:
I couldnt get the fps above 220
I bumped the hpr up to about 210
I bumped the lpr up to about 65
the dwell was at 10 still
It was shooting 290s but it kicked and was as loud as a tippman i think something is wrong with my engine and very inconsistent