Here you go guys and gals a pictured guide on how to change modes and what those modes look like.*Note that this is for V2 or LE fusions only*
Step 1: Grab your fusion(barrel not necessary yet):
Step 2: Remove the left grip panel from the frame by removing the two set screws with a 3/32" allen wrench:
Step 3: Locate the small blue box with the four DIP switches contained in it:
Step 4: Select your mode by putting the correct combinations of ON and OFF selections on the four DIP switches.(All modes, included in the manual and discovered by me and not in the manual are shown below)
Step 5: Replace the left grip panel by re-screwing the two set screws in there proper slots on the grip panel:
Step 6: Follow manual's instructions on chronoing and placing air tanks and hoppers properly
Step 7: Mow faces
All modes included and not included in the manual are shown here:
CFOA(Semi-Auto 15bps)
NPPL(Semi-Auto 25bps)
PSP(Ramping 15bps)
Ramping 25bps
Mill Mode(Ramping 15bps but with no one second wait between bursts)
NXL(Shoot 5bps in Semi-Auto then 15bps Full-Auto)
Full-Auto 15bps
Full-Auto 25bps
These I discovered while tinkering:
Mill 25bps(Same as Mill Mode but 25bps)
NXL 25bps(Same as NXL but 25 bps Full-Auto)
Please feel free to PM me or post other "hidden" modes that you have found and that I have not listed.
