Havent heard of this problem before, so I thought I would post it here....
I own a Marq6, that has been shelved for almost 6months now because I stopped playing paintball for a while, but now when I took it apart to lube it, the poppet was stuck in the front part of the engine, where it holds the spring in place kinda...
So, I removed it with a pair of needle nose plyers and it was stuck in there pretty well.
The delrin/teflon/plastic part of the poppet is swollen (with or without the oring) and will not fit back into the cup used to hold it in place and seal and hold the spring in place.
The OD of the poppet just to the slanted side of the oring groove is .519".
Anyone have a pair of calipers they can use to measure their poppet so I can tell how much it has swelled? And think this will be covered under warranty by BLAST?
Could you give a few reasons as to how? I'm just wondering because I don't think I've heard of that happening.
__________________ Official "I'VE HAD IT" Sales: #1 Darq Marq, CP Kit, JT Streetball Jersey, Vintage JT Pants. #2 Derder, 720 Video, NPPL. Some Invaluable Words of Wisdom: A wise man's heart directs him toward the right, but the foolish man's heart directs him toward the left. -Ecclesiastes 10:2 If you're not a liberal at twenty you have no heart; if you're not a conservative at forty you have no brain. -Sir Winston Churchill "Lousy Democrats."-Homer J. Simpson