[kngai]

I'm looking for a dummy 12g CO2 that fits into the Zeus G2+ AND DOES NOT requires me to cut the gun or drill any holes to feed a macro line through. Is there such a dummy CO2 where a macroline can be fed through where the side holes are?

Reason I'm asking is because I don't like the bulky bottom-line for the gun as:
1.) I can't easily slide the gun into my holster (without unvelcro-ing the strap to allow the bottom line to pass through). I use an Ariakon Holster if you're wondering.
2.) Adding a bottom line to a pistol doesn't make it look like a pistol.

My mod idea is to run a macroline from where the dummy CO2 is, along the side of the gun, connected to an ASA held by a scope ring (attached on the side as well), and then run a remote line through that. I actually made a homemade dummy 12g CO2 using parts found from your local hardware store, but it leaks where my home-made dummy connects to the puncture pin of the gun so I gave up on it. Here is what I mean, similar to this picture, except where the line runs along the side and the ASA is also attached to the side of the gun:
http://www.pix8.net/pro/pic.php?u=11130S5RAi&i=1058339

I adopted this idea from AgentSmith in the Warsensor forums. He runs a macroline from his dummy (homemade dummy) and to an ASA just below it (held by a scope ring). He then attached a small 45gram CO2 tank.

Any ideas or input would be great.

[Castro #66]

What you have in the picture there is actually a more complicated version of the standard bottomline setup.

The Dummy 12 grams are available on Palmer's website, which is probably where the one in that picture is from.

[kngai]

I actually am trying to mimic that complicated setup of the bottomline, except my ASA and macroline will run along the side of the gun, not to the bottom of the grip. I have all the right tools needed. All I'm missing is the right fitting of a dummy 12gram.

The female hole on that Palmers 12g dummy is actually a little too short on a Zeus G2+ (unless I'm wrong), so it would be concealed within the 12g chamber of the gun.

[Castro #66]

If you call them and ask for one to be made for a G2, or to move the hole a little bit, they will probably help you out.

[kngai]

Thanks. I just emailed them about making a custom dummy 12gram. Hopefully they can make it, especially with my effort of making this diagram for better understanding

[pizzaluvr]

Put a scope ring on the side rails, then put a duckbill in said scope ring. Or if there was a dovetail rail somewhere you could just put a dovetail ASA on it. You could probably find another mounting place and just put a male QD on that as well.

[AUTOMAGOMATIC]

5 minute on the lathe and i'll have one..lol