Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 06-23-2008, 05:23 PM #1
international
 
 
Join Date: Jun 2008
new stock triggers

What is going on with the trigger that comes stock on the marq 6s now? They are worst then last years stock triggers. I loved the triggers that had the solid back side, but now they come with a milled out back side that. I can't get the latter one adjusted like I could with the solid back (non milled) trigger. Anyone else notice this?
international is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 06-23-2008, 06:03 PM #2
the incubus
BLAST Manuals '05-'08
 
the incubus's Avatar
 
Join Date: Sep 2003
Location: Miami, FL
the incubus is a Supporting Member
 has been a member for 10 years
the incubus supports Pev's Paintball
You're doing something wrong. They should adjust the same, if not better. They are milled out back to reduce the likelihood of bounce and make for a snappier return.

The Original one was heavy and very difficult to set up without bounce as the geometry on the Microswitch activation Screw (bottom screw) was not quite right.
__________________
POWER - Performance Optimized Weapon Enhancement Research
VICTORY & G6R TRIGGERS AVAILABLE GET YOURS TODAY!!!
Custom Colors Available!!!
GEN5/MARQ POWER Series Triggers will be run in VERY LIMITED Quantities! Currently Sold Out but can be run again with 25 Pre-Paid Orders!!!

www.boblongdirect.com BLAST Manual Specialist '05 - '08
www.tadaotechnologies.com The Yakuza has arrived!
www.125customs.com The best in Paintball Anodizing!
the incubus is offline   Reply With Quote
Old 06-23-2008, 06:20 PM #3
international
 
 
Join Date: Jun 2008
I like my triggers with a longer pull, then this "new" trigger will allow. I can only adjust the activation point a small amount before the trigger hits the frame. So lets say I want a longer pre travel pull, I back the activation screw out. (Away from the microswitch) Problem is that it the trigger hits the frame before the activaction screw hits the microswitch.

The original trigger did NOT have this problem. The "adjustment" on this trigger is well short of the non milled one. I am stuck with a short pre travel, and short post travel trigger set up.
international is offline   Reply With Quote
Old 06-23-2008, 07:02 PM #4
Hell-Intimidator
PSN: GrimTheRipper
 
Hell-Intimidator's Avatar
 
Join Date: Aug 2004
Location: Steeltown
 has been a member for 10 years
Go to B/S/T thread and buy a original "ONYX" trigger. I used to had a trigger without milled on the back cause lot of bounce problems on my old "ONYX" until I had a Rapper with milled trigger. It's way much better and quick snappy return.
__________________
Old~Feedback!
GunWhoreClub #25
Graphic Artist/Design & Photography
Artist at EXCEL Sportswear
Hell-Intimidator is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump