Originally Posted by DocR
I'd be very interested. The big key with them is going to be solid enough to cover the eyes and look good but at the same time semi flexible/moldible to be able to cover a general body but be adaptable to cut down bodies.
i have made 3 of them so far getting better and better each time. the first one was to short. the second one was a little short and i tried a tab that would go into the trigger frame! i did'nt like it. the third one is made long enough that i can cut it to the trigger frame with no gap's.with the channel cut out of the back I found that it can be molded some what
(it's not rubber lol). and as for the cut down body's i havent seen one that was cut down from top to bottom. and most of everyone used the eblade eye drilling detail for there eblade. when I'm done with the third one i will post a pic of it.