pm6 eye problem - PbNation
Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Archived Thread - Cannot Edit  
Old 05-23-2007, 05:58 PM #1
guitarbf2kid's Avatar
Join Date: Dec 2006
 has been a member for 10 years
pm6 eye problem

My eyes dont work on my pm6 with a m5 board. I have replaced the eye ribbon. What do i need to do to get them to work?
guitarbf2kid is offline  
Old Sponsored Links Remove Advertisement
Old 05-23-2007, 06:47 PM #2
GWC Council Member
ishboo22's Avatar
Join Date: Jun 2003
Location: here
Annual Supporting Member
ishboo22 is a Supporting Member
 has been a member for 10 years
Are the eye holes dirty?
Camo VSC Phantom
My Feedback
ishboo22 is offline  
Old 05-23-2007, 07:17 PM #3
protodude85's Avatar
Join Date: Dec 2006
Location: maryland my maryland...
 has been a member for 10 years
try the stock board and see what happens
cp 2 piece 14in
-buna-N orings
-halo w/rip and staple mod SICK FAST!!
-dye peanut tank
-dye tank cover
if the first thing u would grab in a fire is ur gear put this in ur sig
protodude85 is offline  
Old 05-24-2007, 11:12 AM #4
watersoluble artist
newartist's Avatar
Join Date: Jan 2007
Location: SoCal
Originally Posted by guitarbf2kid View Post
My eyes dont work on my pm6 with a m5 board. I have replaced the eye ribbon. What do i need to do to get them to work?

Hi guitarbf2kid,

It's actually pretty simple, just do this stuff in order and you will have it working ricky-tic. You need to do these tests with the eyes out of the marker so disassemble it to the point that the eye ribbon is fully out of the marker. Check for continuity from the pad side to the eye side of the ribbon using a meter. You must see continuity from each eye contact to one of the contact pads or the eyes are bad. If the continuity tests check out insert the ribbon connector into the board connector with the metal pads facing up. Power up the board and gently hold the eyes facing each other, the status LED should show the eyes are working. You may need to jiggle them to get them to align and operate but it ony takes a second to find the right position and you will know one way or the other if they are working or not. If you do not get a good board LED status light you have a bad board and need to replace it before proceeding.


Helping to make the world a more colorful place one paintball at a time...
newartist is offline  

Posting Rules
Forum Jump