ETek Parts ID--Help! - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 05-11-2007, 10:46 AM #1
NetMedic
 
 
Join Date: Mar 2007
Location: West Michigan
ETek Parts ID--Help!

I just got back my marker from being anodized and I have a problem with assembly.

When I sent the marker in I could not get the elbows off the OOPS or the swivel on the regulator so I left them on. When I got my parts back..the elbows were off and I has 3 extra parts with the elbows. I cannot find these parts in the manual..can someone ID then for me and tell me where they go? See attachment.

DSC_0001.jpg
NetMedic is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 05-11-2007, 11:46 AM #2
Jack Wood
 
 
Jack Wood's Avatar
 
Join Date: Jul 2001
Location: Planet Eclipse, England
Annual Supporting Member
Jack Wood is a founding member
 has been a member for 10 years
Jack Wood works for a Paintball manufacturer
Jack Wood owns a Planet Eclipse GSL
The Brass (gold color) part is the valve stem guide and screws into the front of the rammer housing. This needs to have some light Loctite on it when you assemble it and DO NOT over tighten it.

The 2 silver parts are the pin and the insert out of the ASA (OOPS) main body. The insert drops in thin-end first from the tank side, and then the pin slides in thin end first into the centre of the insert. Oil both the small and large o-ring before installing the insert into the OOPS body.

Jack
Jack Wood is offline  
Old 05-11-2007, 12:28 PM #3
NetMedic
 
 
Join Date: Mar 2007
Location: West Michigan
Thanks a lot...Never a good thing to have extra parts.
NetMedic is offline  
 




Posting Rules
Forum Jump