[D_Squared985]

alright guys so I have a wee bit o problem, my tape worm broke in half leaving the bottom half with the orings and such still inside of where you install the tapeworm at.. have yet to attempt to drill it but want to save that as a last resort..
so far i have tried super gluing a screwdriver and letting it sit on the broken half for awhile but it still wasnt strong enough to pull it out, i have also tried just plain old leveraging it out with a screwdriver but that also was to no aval.. at this point im open to suggestions.. anyone?

[Dyoel182]

My vote would go to drill/easy out.

[xxxfrankensteinxxx]

nooooooooooooooooooo dont drill it if you have the threaded part out use a long stick and push it out from the other end of tube or just push out whole co2 filter ive done this b4 dont drill it if you have treaded part out!!!!!!!!!!!!!!!!1

[jasper371]

Originally Posted by xxxfrankensteinxxx

nooooooooooooooooooo dont drill it if you have the threaded part out use a long stick and push it out from the other end of tube or just push out whole co2 filter ive done this b4 dont drill it if you have treaded part out!!!!!!!!!!!!!!!!1

Definitly

Why drill when you could just push it out?

[D_Squared985]

thanks for the helps guys i folloewd your advice and just pushed it out the back.. wow i feel like an idiot now.. but thanks for the help..

[xxxfrankensteinxxx]

no problem it happened to me to so im wondering what quailty alluminum they use, oh will they replace it you think? cause i can never get ahold of the sp techs

[D_Squared985]

im not even going to try ha ha..