Originally Posted by flight cancled
Three battery mod-
(you need a 9 volt battery connector, superglue or double sided Velcro, and a drill or knife) cut the red wire going between the two boards. connect the red wire coming form the circuit board to the black wire of the connector. Now connect the red of the connector to the red coming from the battery board. Now drill or cut out a hole where the two halves of the ball ramp meets so that the wires can fit in the gap. Now is where you make a decision: Do you want the ball ramp? If not mount the 9v using one of these super glued or velcroed to the bottom of the ball cavity under the door.
Can also be done with the battery conector mod the same way by substisuting the two main connecotrs for the battery board in the diagram.
If you want to keep the ball ramp you can cut out a little strip where the upper corner of the ramp can fit.
i improved this mod.i wired a switch into the circuit so that i can turn the mod on and off.because i burnt up my old motor with this mod. the diagram in the pic tell how to do the mod.in the pic it shows a 3 way slider switch, you can also use a toggle switch.
i make custom spyder triggers pm me for details
"Originally posted by invader zim
Ball valve and a midget with an electronic shock collar! The new e-marker!"
"Originally posted by Ocelot
The autococker is a fickle mistress. They requires lots of affection and care. Without constant reassurance and cuddling, they will refuse to play with your balls and will most likely leave you, call you an ******* ... then take half your stuff."