[Diablo Wrath ESP (Banned)]

Hey, I'm currently trying to find a noid that I can put in my wrath to make it fully EP. What kind of noid does the NME use? I searched the faqs already, and found nothing. A link to the manufactorers website would also be very helpfull. Thanks.

[jayrd21]

well system x is out of business so no website to be giving links too. but the NME nois is the same as one from an intimidator
http://xtremepbma.com/store/product_info.php?cPath=26_29&products_id=92&osCsid =f676ae6e8d1db7f897fa2830d0101aaahere is the cheapest place to buy one new plus it gives you a picture of what it looks like

[Diablo Wrath ESP (Banned)]

Thanks a lot dude.

[Diablo Wrath ESP (Banned)]

Also, what's the operating pressure that nme run at?

[nme2110 (Banned)]

80 psi and shuter shooter is selling noids for nmes

[loser555]

the hpr runs at 2hundred something i beleive and the lpr runs at 60

[little_dude57]

If you need a solenoid for the NME, get a standard Humphrey that is used in Intimidators. You can find one at www.xtremepbma.com or www.airsoldier.com. The LPR should be set between 50psi and 100psi and the HPR should be set between 200psi and 300psi.

[nme2110 (Banned)]

i ment the gage shuold read 80 also how come i have to run my lpr at 80 or thats what my feald tech said

[little_dude57]

You can have the LPR operate at a lower pressure, but you would then have to increase the dwell to allow enough pressure to flow through your NME. Try lubricating the LPR, HPR, and ram. Adjust the settings and pressure until it suits you.

[Diablo Wrath ESP (Banned)]

Well, I don't have an NME, I have a diablo wrath, I'm trying to find an ep noid that would work with the wrath. I hate the mech solenoid int he wrath. The psi levels seema bout right with the wrath and that noid. I just need to know the voltage. Thanks again guys.

[little_dude57]

I don't know the voltage for the solenoid, but this is what is on my Humphrey out of my Intimidator.

HEA10F5-GL-101W
5VDC
0.2 ~ 0.7MPa

[Diablo Wrath ESP (Banned)]

Thanks, that may come in handy.

[ShutterShooter]

Originally Posted by little_dude57

I don't know the voltage for the solenoid, but this is what is on my Humphrey out of my Intimidator.

HEA10F5-GL-101W
5VDC
0.2 ~ 0.7MPa

That's the exact same one used on the NME.

[little_dude57]

I already know this, but I gave him that information to use.