OK! well we have two ways of cleaning here! JJ's way with oil and toolsheds with grease! Neither have pics and I thoguht we might need one(well my parents went to the shaw festival and I didn"t want to go....so.....)
This way is more of a hybrid.......it uses both oil and grease. I'm using my ltd so it may difer a bit with the non ltd wrath!(yes I know my macro-line is longer them my gun....I just got the on-off and I didn't have to to cut it....what are you gona do cry? cuz thats what I was doing when i was playing like that
allright....get all you stuff ready to go!
Right now the next part. Its time to take out your ram(mer). To do that you are going to have to remove the rear grip frame screw. Now that doesn't sound to hard?
After removing the grip screw, remove the ram cap. Theres 2 things that can happen....either your ram will shoot right out or come out easy(but it will be stoped by bolt)....Grab the bolt pin and pull back to remove the bolt and ram together.
Right now take out the rest of your ram and get ready to clean and lube!
Ok wipe of old grease or oil(Im gona be using oil on this but grease should be ok)
Ok lube her up!....This step should be super easy for some of ya
then put your ram(mer) back togather and put it back in!
Ok good remember the screw you took out? Put it back in.....now onto the bolt...same story wipe of old oil and put some new stuff on BUT JUST A LITTLE!!! AND ONLY ON THE O RINGS!!!! the bolt can swell and thats not good!
Ok....put the bolt back in making sure that the in goes into the hole on the ram.....MAKE SURE! Now its on to the HPR inline reg! This isn't going to completly take it apart but for your evreyday playing this is good! So start by un screwing the botton half of the reg!
Ok now tap it onto your palm so that the stuff inside falls out! Then get ready to lube!
So wipe of the old grease( for the regs I use grease....dow 33)
ok grease it up and put it back in the botton of the reg and screw it in back into the reg...your greasing the large piston namly the o-ring on it
Ok next up is the lpr....Now you remember that screw on the back? now its time for his evil clone sister whos a real ***** compared to her....thats to the angle of the reg it can get hard to get it out but you will prevail at some point....then take your lpr out! and if the popit and spring come out you might as well put it back in...we don' need i right now
ok time to take it apart...Now like the HPR I'm not gona take it all apart. So take out the adjsuting screw on the front of it.
Allrighty out comes a spring and piston just like the HPR. same thing as with the reg....wipe it off and grease the piston oring...
Now put it back in and have fun with Mrs. E screw
then you will be done! I do this after evreytime I play and before I go!
Now take a look at my kind of nice looking wrath!
If you have any questions PM me or ask on the forum! and if you brake your gun doing this its your fault not mine! I do this all the time and it hasn't caused any problems! If anyone finds a mistake post or PM me and I will fix it asap! Enjoy!
Made by "eveymarkeritoucdies"(MacKenzie)