Quick Timmy Question... - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 08-07-2006, 12:30 PM #1
MatDaddy
 
 
MatDaddy's Avatar
 
Join Date: May 2005
Location: Iroquois Falls,On,Canada
Quick Timmy Question...

Just cleaned my dads Dark Timmy...a bit overdue I may add. For some reason it seems theres more airflow going through the CP reg now or something because I need to back out the LPR almost all the way so it dosen't exceed 80 psi. Tried it yesterday with some 2nd grade paint and it was chopping/breaking like mad. Cleaned it all this morning then tried it with some Tempest paint and it was shooting fine. So im wondering if theres something wrong since before the lpr was flush with the body, now its sticking out like a permanent hardon. Suggestions?
MatDaddy is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 08-07-2006, 12:36 PM #2
W.K.S.
Spool Valve Sensei
 
W.K.S.'s Avatar
 
Join Date: Apr 2006
Location: Snohio
W.K.S. has achieved Level 3 in PbNation Pursuit
W.K.S. is attending Decay of Nations VII
Back out the hpr, reset the lpr to 80, then adjust the hpr to the desired fps.
__________________
W.K.S. is offline  
Old 08-07-2006, 12:44 PM #3
MatDaddy
 
 
MatDaddy's Avatar
 
Join Date: May 2005
Location: Iroquois Falls,On,Canada
Did exactly that...its just that the screw for the LPR is sticking out more than it was before. LPR is at 80 and hpr is ajusted so it can shoot 280...im just wondering if its normal for the screw to be that far out.
MatDaddy is offline  
 




Posting Rules
Forum Jump