[Nasty_Imp_Freak]

Ok i have this little gold thing that screws into the vertical maxflow...dont know wut its called but it leaks like a b**** and i really wanna get my imp working...I tried the handy man secret weapon (ducktape) but i dont think thats gonna cut it...i was told that i need to turn the pressure down but i dont know how to do that either...HELP!

[homerj]

ok, if you have a max-flo you turn the pressure down by twisting the knob (on the bottom if it's vertical on the front if it's horizontal) counter-clockwise. your pressure should be around 180-200psi. if it still leaks then you can take it off until you're able to replace it. it's a prv (pressure release valve). it's supposed to leak if there's too much pressure going in so your solenoid doesn't blow. btw, keep the duct tape far far away from your imp. lol.

[readthisanddye]

Originally Posted by homerj

.....btw, keep the duct tape far far away from your imp. lol.

haha, word

[citydweller]

for thaat little gold peice you need teflon (sp?) tape. lol not duct tape

[Nasty_Imp_Freak]

Ok guys if it wasnt for u i would still be in a cave inventing the wheel

[Audi90quattro]

While the PRV is off your gun, dont set your pressure any higher than 200 to be safe. The PRV is supposed to vent at 240 psi I believe. Without the PRV and any pressures near that could damage the solenoid.

[Nasty_Imp_Freak]

ohhhhhhh.......thx...wich way do i turn the thing on the bottom of the vertical maxflow though? lefty loosy or righty tighty? to lower the pressure

[homerj]

turn your imp upside down. looking down at the max-flo, turn it counterclockwise to lower pressure. shoot it a couple of times in between turns.