eyes

pballndad · 03-03-2006, 12:01 PM

sorry guys, have to make this quick. My computers down at home and I am on one at work and don't have time to search. I have the t-board w/ultra chip and my eyes don't work. I get the light when in calibration. if I change the wires to match up I don't get the light. Either way my eyes don't work so I've removed them.I can turn up my rof and miss a ball about every four shots while ramping pretty hard and would like to keep the gun from firing without the ball. any ideas?

Alamo City PB · 03-03-2006, 12:13 PM

Yes, ditch the adapter harness. Plug your eye wires directly in to the black harness that the adpaters split of off. They should be in this order:

Note the direction the black harness is facing.

This has worked on every Wrath I have installed a T-board in.
Max

pballndad · 03-06-2006, 12:23 PM

Thanks, it worked. I did have a problem with the gun shutting off though. I completely broke the gun down and reassembled it and it started working fine again. Not sure what was happening there.

nat · 03-06-2006, 05:58 PM

^^^^^^^T-board on/off button may be a little longer than stock ones,thus pushing on the membrane pad!!!!

Wrath130 · 04-22-2006, 11:14 AM

I did this to my eyes and it only works on my tboard, it wont work with the ultra chip. What could be wrong?

\m/-__-\m/ · 05-24-2006, 03:45 PM

how risky is it unplugging the eye wires from the stock white harness?

Alamo City PB · 05-25-2006, 01:03 PM

Quote:

Originally Posted by Wrath130

I did this to my eyes and it only works on my tboard, it wont work with the ultra chip. What could be wrong?

Perhaps you installed the chip incorrectly. I have used the method I posted above on both standard t-boards and ultra chipped boards.

Quote:

Originally Posted by \m/-__-\m/

how risky is it unplugging the eye wires from the stock white harness?

Not risky at all when done with care and patience. Just take your time and slowly pry the tab up as little as possible to remove the wire. I have done it many times to the harnesses and never has an issue. Just remember do not force it, it should slide out with ease when done properly.

\m/-__-\m/ · 05-25-2006, 01:04 PM

yea i did it yesterday. everything works great!

FuelTheFire · 01-22-2007, 09:34 PM

I have the t-board as well. im sorry but i dont really understand exactly what i should be doing with the wires. Also i have broken a black wire from its white plug...can i re-attach this wire? or do i have to buy new eye wires.