PT Extreme leek help!!

[RETOOHSPRAHS]

im trying to add a bottom line to my pt extreme so i added everythin to it and now it leeks out the front area weer the 12 gram gos if anyone knos the proper way to install a buttonline on a PT extreme pleese tell me or if u kno any helpful links thanks

[neo71665]

Most ppl take a empty 12 gram drill a hole in it and tap it. Then take yor hose and screw it in the hole. Mount you ASA and there ya are. How did you do it?

[toolshed rec-face]

If you have your bottomline screwed into the body too far, it will push against the valve and cause it to leak. Otherwise, it is leaking because the seal on the puncture end of the valve is blown. Replace valve.

The way you need to connect a bottomline is to first strip the gun down to nothing but the body. Then you need to apply Loctite or Teflon tape to your hose fitting. Screw the fitting into the body until you start to see it when you look down the lower chamber. Make sure it is not projecting into the chamber at all or it will obstruct the valve during reassembly. Now reassemble and you're good.