Ripped harness

[KLyMaXx]

My harness is broken and I need a new one, is there any after market harness??

[ollie_olsson]

check out crankwalk (he's a member on the nation), he sells stronger ones.
15USD + shipping

But in the mean time, you can do what i did to fix it...really ghetto like.

Note: I don't have the equipment nor knowledge about soldering so that's why I didn't do it.

remove the pins in the molex connector on the harness.

Then strip the plastic off the wire only about 3-5mm, enough so that you can twist it, and make it "stable" and doesn't fray.

Then place the wire into the hole where the pins were (make sure you get the polarities right, you don't want to fry your board). And then push the pins in AFTER the wires, so that their kept in their place.

Test the harness, see if you can even start the board up, if it all works, just put some epoxy or other strong glue to keep the wires in place.

This is a nice temp. solution for everyone's problem who doesn't know how to solder....good luck!

[KLyMaXx]

I have a solder and know how to sort it out, but I cant buy the parts that fit in the board, so I can manage myself for a whyle, but I definitely need a new proper harness, so Crankwalk is the man, right?
THanks

[jd_mattos]

Ya crankwalk sells good ones... I have one in right now...PM him...

[cjm555]

as do I...very nice

[KLyMaXx]

Got in contact with crankwalk and FEP has contacted me offering help, +1 for FEP eurpean service :)