Quest eyes

[foam27]

Ok, the eyes on my quest are not working at all, I know the first thing that comes to mind is just to replace the eye harness, but all of the wires and the connector looks fine, no loose wires or bent pins, is there anything else it could be ? just wanted to check before I get new eyes.

[ghost271]

I would just get a set of new eyes. At times the wires may look connected but infact somwhere within the line it has come loose, or pinched

[Physcojosh]

also double check your board settings. and make sure you are infact playing with the eyes on...

Also.. if you used some Cheap Paint.. like Wildstreak, then it may stain the eyes.. happends all the time to Ions and such..

[kleivonen]

Stained eyes would SUCK. a lot.

[foam27]

On my rail, when the eyes break or whatever, the noid still clicks, just at a capped rate, the quest just acts as if there is nothing in the breach at all, solid red light and no noid clicks, is this what its supposed to do ?

[LU_aDaK]

replace the battery just to be safe....and make sure you didnt put the eye wires in the noid slot.

[foam27]

yea the battery is brand new, and the eye plug thing is the one to the right, right ?

[foam27]

and I have another question, when I set my gun to psp, I turn the gun on, then turn the eyes off and shoots in semi, thats not how its supposed to be is it ?

[ghost271]

and I have another question, when I set my gun to psp, I turn the gun on, then turn the eyes off and shoots in semi, thats not how its supposed to be is it ?

If its in PSP and you turn the eyes off, it should still act like PSP ramping just capped at 12bps I believe.

[foam27]

well when I turn it to psp if I turn it to simulate then it ramps but its capped at like 5bps, but when I turn the eyes off it shoots in semi, I havent tried it with eyes on yet (obviously because they dont work).