Settings?

[cococody]

I just bought a quest from a guy and the gun is acting wierd, shooting inconsistency. are most of you guys running stock settings, and the gauge on the foregrip is that the lpr or hpr?

thanks.

[NYGuardians capt.]

the gauge is for the LPR, and we are running stock settings i think syntax is the only one that isnt. post what settings you have and we might be able to help.

[cococody]

i just reset everything to stock and i put the lpr to around 100 but the gauge jumps sometimes. also i tried adjusting the regulators like in the book. are you guys using the stock barrel or freak kit?

[NYGuardians capt.]

ahh no your lpr should be closer to 80, and if its jumping then something's wrong. try relubing your HPR and if that doesnt help try replacing the noid.

[jeffreyjames]

check your lpr spring. if its soft it will not function properly. there are a few threads about this in the forum. try more lube or replacing your orings. your noid should be one of the last things you look into. it is very hard to "blow them up". also make sure all the connections between your board and noid and everything else are good and firm.

not trying to undercut you nyg.... its just that an actual bad noid is not very common. and pressure jumps sounds like seals somewhere, either in the bolt works or regs.