PDA

View Full Version : Need some advice

LittleWarrior
03-30-2007, 04:38 PM
When I air up my quest and dry fire a few times everything is good, but if it sits for a bit the LP gauge slowly starts to creep up highier? Any ideas!!
Gailon
03-30-2007, 04:53 PM
It's an oring in the bolt assembly. Try the rear or middle pin or the back bolt if i remember correctly.

ADD: Yeah check the 017's and the 018's.
LittleWarrior
03-30-2007, 04:57 PM
It's an oring in the bolt assembly. Try the rear or middle pin or the back bolt if i remember correctly.

ADD: Yeah check the 017's and the 018's.

I changed the middle one on the bolt (blue in color) kind of helped but still creeping up....Shit gotta play this weekend!!!!
ArchAngel666
03-30-2007, 05:08 PM
I have a stupid question: Did you relube it and reassemble it right?
LittleWarrior
03-30-2007, 05:11 PM
I have a stupid question: Did you relube it and reassemble it right?
LOL......Yeah relubed... and it's pretty hard to reassemble it wrong.....two pieces, somewhat simple I think.....lol.....I think I need to change all the orings to be safe.....
ArchAngel666
03-30-2007, 05:18 PM
I was just makin sure... You never know with some people on the Nation.

I would say that changing all your orings would be the best choice, and it looks like thats what you're doing. Maybe someone who knows more about Quests (which is just about everyone here seeing as I'm new to them) will have a definitive answer for you.
LittleWarrior
03-30-2007, 05:24 PM
Thanks for you input and honesty....have you taking you bolt and pin out of yours yet....you will see that even a blind person could do it, they are very user friendly until you get some small prob like mine.....but for me I guess it's a matter of order of elimanation.....anyone else have any ideas!!!
ArchAngel666
03-30-2007, 05:28 PM
Oh yeah, I've taken mine apart and everything, quite simple compared to similar looking guns *cough*shockers*cough*. They made it easy to work on, which is a big :tup:
I was just saying that I don't quite know what causes something to act a certain way in a Quest. Pretty much that I don't know how to properly diagnose the problems with them yet.

Anyhow, good luck.
Gailon
03-30-2007, 05:38 PM
make sure you replace the ones on the Pin. Usually when I get creep it's more likely the Pin orings then the bolt. Start from the back and work forward.
LittleWarrior
03-30-2007, 06:02 PM
make sure you replace the ones on the Pin. Usually when I get creep it's more likely the Pin orings then the bolt. Start from the back and work forward.
Thanks Gailon.....Might be a good idea to start at pin....I just hope I have all the orings in my kit to replace them all!! Really gotta get this thing working properly....