PDA

View Full Version : First -REAL- Problem

ArchAngel666
03-15-2007, 10:29 PM
I shot my Quest today, so I decided it would be the perfect time to relube it.
So I unscrew the Pin thing at the back and lube up its Orings (6 I think)
Then I take out the Goldmember and lube its Orings up (3 I think)

Well, I pop the bolt back in, then the pin thing, and screw it in. I turn the air on and all i get is a leak down the barrel, any ideas?:confused:

PS. Love the gun so far, and this leak is surely my fault, seeing as its my first time lubing it.
LU_aDaK
03-15-2007, 10:45 PM
little more lube on the front 2 bolt guide orings, might have to swap them if it doesnt go away.

A good trick is to take them off and put lube under them.
ArchAngel666
03-15-2007, 10:59 PM
little more lube on the front 2 bolt guide orings, might have to swap them if it doesnt go away.

A good trick is to take them off and put lube under them.

That worked, thanks.:tup:
LU_aDaK
03-15-2007, 11:00 PM
:tup:
1969
03-15-2007, 11:19 PM
:tup
socal*baller
03-16-2007, 02:56 AM
free up for someone who played at urban quest. and owns a few quests.
VC_UPROAR
03-16-2007, 03:02 AM
check or replace the last o-ring on the bolt pin. Do not lube that o-ring.
That worked for me. Hope it works for you!

Quests take a lot of lube in break in, and a lot of very tender extra care, be good to your Quest, and believe me it will be good to you!!

FEP baby FTW!