I need help!!! befor thursday!!!! HELP ME!!

[DarkDreams63b]

I was just cleaning my quest and i was about to take the batterie off then i noticed that one of the cables was disconnected! Where can i accuire one before thursday?!!?!?!?!?!?? HELP ME!

[Chicago Quest]

is it broken or unhooked???

[DarkDreams63b]

the cables came off the connected like broke off

[tesguy]

only thing you could do on such short notice is to find someone that can solder stuff fairly well. Solder the connection back to its original state, then after the tourney, call up FEP.

[DarkDreams63b]

hmm that might work

[Physcojosh]

off the Noid or the Board... im pretty Sure Sodering Voids Warrenty... If it just came out of the White thing, I think you can Put them back in... <Open White Connector, Insert Wire...

[DarkDreams63b]

no they came off the connecter that connects into the board. so the black white part. how do you take apart the connector?

[Sagg]

take pic and post it so we can understand better

[Jkennedy]

I had the same problem with mine too. The black wire for my battery broke off so i just solder it to the back of the board. It dont void your warrenty either. Mine just got back from FEP cause i had a stripped feedneck and they never said anything about my soldering....

[The EastCoast Kid]

take pic and post it so we can understand better

QFT :tup:

[bronc.v2]

The wiring harnesses that come with the WAS boards suck. They use small gauge wire, when they should have used a thinker gauge. I've been told that the new Lucky boards have better harnesses when they start to ship. CPS is going down later on this week to pick some up, so I'll know when I get one in my hand.

As far as the battery harness goes, all you can really do it push the wire back in the plug until it makes contact and works. Put some tape on it to keep it in until you can get a new one from FEP. Unless you have a crimper, you're not going to really be able to fix it properly. I wouldn't really mess with soldering it to the board itself, since it's not easy to do and if you get too much solder in the plug you can bridge the two contact points and short out your board (ya I'm guilty of it myself).

I've been through 5 WAS boards and 2 stock boards already in my marker. I'm so hoping the Lucky boards are better.

[Chicago Quest]

7 boards lol

[Physcojosh]

ya your Just King of Bad Luck Was lol. I may pick up a lucky board, not sure tho.. I wanna shoot one first :P

The wiring harnesses that come with the WAS boards suck. They use small gauge wire, when they should have used a thinker gauge. I've been told that the new Lucky boards have better harnesses when they start to ship. CPS is going down later on this week to pick some up, so I'll know when I get one in my hand.

As far as the battery harness goes, all you can really do it push the wire back in the plug until it makes contact and works. Put some tape on it to keep it in until you can get a new one from FEP. Unless you have a crimper, you're not going to really be able to fix it properly. I wouldn't really mess with soldering it to the board itself, since it's not easy to do and if you get too much solder in the plug you can bridge the two contact points and short out your board (ya I'm guilty of it myself).

I've been through 5 WAS boards and 2 stock boards already in my marker. I'm so hoping the Lucky boards are better.

[DarkDreams63b]

Thank You Fep!!!!! I Just Recieved My Wiring Harness! Best Company Ever!!!!!!!!!!!! And Everyone In The Fep Family Thanks For The Advice!