Quest blender

[Shotcaller509]

Ok I took my Quest out and tried it in ramping mode. I have the "WAS" board and put it on PSP 15BPS and all it did was chop. The paint I was using is about a medium grade paint, the battery was brand new, bolt lubed right, lpr is at about 90, fps is in the 280's consistantly, and I made sure the eyes were in good standing, but still it choped paint like you wouldnt believe. Is there something Im not doing right on my settings or something. If anyone can help me out I would really appreciate it. thanks

[The EastCoast Kid]

dwell too high? idk man i was using xball last wek and it was alittle rotted, all i can say is my gun was dripping paint. messiest gun ever, nxl full auto with old paint will do that. sounds liek all your adjustments are correct, could just be the paint...

[Shotcaller509]

My dwell is set at 12 right now. Is that too high???

[jeffreyjames]

chopping or barrel breaks? could have just been bad paint or maybe too large for the bore of your barrel. was your loader feeding fast enough? put fresh batteries in your loader, set it to a faster speed(as long as it doesnt push paint past your detents), check your detents or bump up your bip delay.

[PunxPB]

When I play with okay paint and it begins to sweat I will chop out the barrel. I increase the barrel bore and no problems after that.

[Uiruru]

My dwell is set at 12 right now. Is that too high???
Thats pretty high considering the stock dwell is 8.