PDA

View Full Version : Won't shoot.

PunxPB
10-15-2006, 05:44 PM
So this weekend I was getting ready to play with the Quest. Aired it up and I had a leak through the trigger frame. Pulled out the bolt and snatch pin and replaced both front o-rings, went to air up again and no leak.

But when I turned on my Quest and pulled the trigger, nothing happened. This was with the eyes off. So I turned them back on put some paint in, and still nothing. It shows that a ball is there but nothing happens. Looked in the manual and followed the steps. I changed out the battery and still nothing. I increased my dwell from stock to 10, still nothing. Made sure I didn't over lube, check the HPR and LPR and still nothing. Check the wires coming from the solenoid and nothing looks like they are broken or came out of the board. My lpr was set at 90, raised it to 100 and still nothing. I even back out both the lpr and hpr and started over just like I got the marker for the first time, and still nothing.

I have put about 5 cases through it with no problems till this weekend.

Any help would be appreciated.
Uiruru
10-15-2006, 07:17 PM
Does the Solenoid click? The solenoid wires may be broken under the heat shrink on the terminals. Also try pushing the orange test button on the solenoid.
PunxPB
10-15-2006, 07:23 PM
The silenoid doesn't click. I will try pushing the test button. Thanks.
PunxPB
10-15-2006, 08:09 PM
Pushed the silenoid test button and nothing happened.
The EastCoast Kid
10-15-2006, 08:14 PM
same thing happned to mine, except the test button fired the solinoid on mine. idk what fep did to fix it but they fixed it. noid works good now, just send it to fep.
ghost271
10-15-2006, 10:40 PM
I would recommend taking the noid out and just shipping that back instead of the whole gun. Its a really simple fix for FEP to do and you'll be up and running in a few days. FEPs great.
PunxPB
10-16-2006, 07:46 PM
Well I talked to Dale today and checked the wires and board, but couldn't see anything wrong. So I am sending it in to FEP, so they can look at it. Thanks to those that replied.
PunxPB
11-04-2006, 12:48 PM
Received my Quest back from FEP. They had to replace the board. Thanks to FEP for getting this done quickly and keeping me informed throughout the process. Another A++++++ for FEP's customer service.
LU_aDaK
11-04-2006, 01:30 PM
:tup: to a member with patience and appreciation.
pu pu pump
11-04-2006, 03:34 PM
fep ftmfw
great customer service