Quest Gen 3 WAZ board settings???

[Shotcaller509]

I just recently got a Quest gen 3 with the WAZ board. I also have a Gold member bolt, and run a 45/3000 HP 850 PSI tank with it. I was wondering if anyone could give me some good settings for this kind of set up, like DWELL, BIP, ect..... Thank you

[kingpen509]

Ummmm I think you should buy a Tippmann A-5 again! J/K C-dog

Oh and your tank is a 68/3000

[imped4now]

It's WAS, not WAZ. WAS=Wicked Air Sportz.

[Shotcaller509]

It's WAS, not WAZ. WAS=Wicked Air Sportz.


Yea whatever you know what I mean, but that still dosnt help me out........

[.:{}:.]

factory settings are the only settings you need! it rips out of the box.

[509_BUTCH]

Yea whatever you know what I mean, but that still dosnt help me out........

Your not going to get any help with that snappy attitude!

[NYGuardians capt.]

dude u don't need any help there is no "settings thread" in here for a reason, quests don't need anything other then factory stock settings

[Chicago Quest]

the only one to mess w/ is rof cap=purple
make sure your loader can keep up

[Intense One]

Read LU's thread for new gun owners... You'll have the gun working great, and set a time schedule on any dwell/lpr adjustments

[Shotcaller509]

Great!!! Thank you to everyone with the awsome tips.....

[Intense One]

QUOTE=Intense One]FEP Quest Join Date: Aug 2006
Location: Stratham NH



--------------------------------------------------------------------------------

Quote:
Originally Posted by Intense One
stock settings are
Dwell- red 8.0ms
Debounce- Green

eye mode- yellow 1flash bypassed 2flashes mode1, uses ROF cap
3 flashes mode2, monitors bolt 4flashes- simulate
default is 2
BIP Delay- Blue 3ms
ROF cap Purple default 15bps
Eye Power- Teal 10 default
Firing Mode- White 1 flash, semi// 2 flash PPL// 3 flash full auto default 1

hope this helps
__________________
Intense One[/QUOTE]