Having trouble fine tuning my Quest

[Forsaken Nukkas]

Hey guys, got my quest about 2 weeks ago, and have been messing with settings since. Um, my dwell is at 8, lpr is at around 50-60 ish and my reg is about 1 turn in shooting close to 300. My only question is, that im gettin pretty bad drop off after i leave it for awhile, also after i cycle the bolt about a tanks worth of air the bolt will studder and not shoot just like half cycle. I lube it and it shoots wonderfull again. The gun has had maybe 4 cases through it and about another 6000 shots of just air, so its pretty well broken in. I tried running the lpr at around 90psi and I had no luck, the gun actually broke paint acouple times and completely chopped a ball in half and got the bolt stuck forward when running at 90psi.... I dropped it to 50-60psi adjusted the hpr to compensate to 300fps and put it on nxl uncapped and it was shooting crazy ropes and very nice, but now I have this bolt prob. I have a tournament tomorrow and need to know what I should do to get my gun to have no problems at the tourny... I dont want my gun going down in the middle of a game, and I really want to shoot it tomorrow. Any help would be very much appreciated.

[LU_aDaK]

get a new battery and

Anti-Bolt Stick – is a built in feature to add additional dwell (ms) to the current dwell after 15 seconds of non-use. It will help eliminate the likelihood of first shot drop off. The default setting is 7 ms and is adjustable from 1 ms to 15 ms.

put that all the way up. If it still has fsdo then be sure to check ur lpr spring.

which generation quest is it?>

[Forsaken Nukkas]

its the newest, with the new verison of was aswell. Um ill put my fsdo all the way up then. Thanks so far.

[LU_aDaK]

just be careful

the first shot will shoot HOTT.

basicall all it does is raise the dwell for 1-2 shots

[Forsaken Nukkas]

Um.... just checked the manual, there is no fsdo...? Also, I think that it was maybe chopping when running a higher lpr because my bip was too low?

[papaintballer15]

there is no FSDO setting. its ABS, anti bolt stick. fsdo is when u shoot once and the ball just either rolls out or goes like 3 ft. but sometimes *cough* shockers,matrix's *cough* they will get msdo (multiple shot drop offs) from 2-10 :P

[LU_aDaK]

Anti-Bolt Stick – is a built in feature to add additional dwell (ms) to the current dwell after 15 seconds of non-use. It will help eliminate the likelihood of first shot drop off. The default setting is 7 ms and is adjustable from 1 ms to 15 ms.

^^^ this is directly from the manual bud.

[Forsaken Nukkas]

ok well um either im fuckin retarded or your looking at the old board manual....this is was....bud.

[Forsaken Nukkas]

o and the fsdo reference is cuz ive shot egos for a long time and its not called abs its fsdo same shit lol.