noid harness

[Jackoblades]

Hey i broke the wire on my noid a while ago and i soldered it. it works fine i'm just lookin for a new harness to solder on there. on mine the wire is broke in the middle so i have two points of solder to break and i'd just like a little stronger harness. I do not know how to make the little metel pieces to connect to the white plug so if someone could sell or give me just a new wireing harness that would be great. I could soler it onto my noid points myself. thanx!

[jeffreyjames]

call fep. im sure theyd hook you up with a new harness, plugs n all. or did you actually break the wires from the noid to the plug? with the break in the middle of the wire like that some heat shrink tubing would help keep it in order so its less likely to break and keep it from possibly shorting on anything. but youve already got it soldered. or some electrical tape(kinda ghetto, but it works). the metal tabs arent too hard to do. i just dont know where youd get the tool and crimp ends small enough to do it. or a way to extract the old one from the plug.

[Jackoblades]

ya you can get the old one out of the plug with a safety pin but i just broke it about halfway between the noid pin and plug on one of the wires. i'll give FEP a call.

[6speed]

If you have a DM5 or PM5 laying around(since you have a Quest all other guns collect dust) you can use the noid harness from that, I acually prefer it and plan to do it to both my Quest's.

[Jackoblades]

i do have a pm5 sittin here but the plugs are differant. I talked to FEp today, chris maybe? and hes hookin me up. thanx!

[NYGuardians capt.]

just switch noids.

[Jackoblades]

i mean the plugs on the board/power hookup. thanx! FEP is hookin me up anyway. i'm sendin out today.