Quest help

[93Travis]

I just got my quest today from a trade, i was woundering if anyone could tell me the best settings to get the best profourmance from my gun and how can i tell if its a gen1 or gen2, also i love mods are there any that can be done to the quest, and one more question whats it cost to get the new grips and how can i get them, thanks for all your help.
-Travis

[Physcojosh]

I just got my quest today from a trade, i was woundering if anyone could tell me the best settings to get the best profourmance from my gun and how can i tell if its a gen1 or gen2, also i love mods are there any that can be done to the quest, and one more question whats it cost to get the new grips and how can i get them, thanks for all your help.
-Travis

Ok man, best Settings IMO ~ Lpr 55, Dwell 6.5,Bip1,Deb 5, Eye mode 3 <I think? uncapped mode> Semi

gen1 Quests have Angel style Grips,No Lpr guageOld bolt Design

gen2 New "Quest" grip pattern,Lpr Guage,new Bolt Design.

gen3 Same as gen2 but with WAS

Only Mods ATM are Timmy~Quest Trig mod.. not hard, all you do is shave off a little Peice of the Timym trig and it Fits..Also Matrix Grips to Quest..Not much of a mod..but Not many have them ^^

And lastly the New grip Design is FREE OF CHARGE Check the Stickys, They arent Done yet, but should be done pretty soon.

O , btw , Enjoy your new Quest ^^

[jeffreyjames]

welcome to the fam. josh pretty much covered everything you asked about. anything else, just take your time to read thru here and youll probably find it.

[93Travis]

wow thanks man i really aperciate it and love the quest is so small i went from a G7 to this and it feels great, but thank yall for the help,
-Travis

[evileric77]

I wonder if they'll sell me an unmilled bolt. All I'd want is the bolt milled for the oring seats but not the flow holes. I have an idea I'd like to try.

http://img80.imageshack.us/img80/3537/bolt8py.png

Without the circled milling

[F0rgiven]

I wonder if they'll sell me an unmilled bolt. All I'd want is the bolt milled for the oring seats but not the flow holes. I have an idea I'd like to try.

http://img80.imageshack.us/img80/3537/bolt8py.png

Without the circled milling

call them and ask them

Also, if anybody was wondering, if you have the Gen2 board and would like to exchange it for the new WAS board, they will let you trade off for $35. If you don't want to trade your old board for it, it will cost $95. Again, just FYI if anybody was wondering.