Cant program Nox Chip

[jbuot]

Got my manual from previous link. It tells me to program the dip switch 2 has to be in the off position. It then tells you to hold the trigger down until the light turns white. I did that. It then tells you to hit the trigger till you get color you want that corresponds to the mode you are trying to change. In my case I want to change the debounce which is yellow. Done. I hold the trigger down and it blinks red once which means debounce is on 1. Proceed to tap the trigger 4 times to change the debounce. It confirms that I change the setting to 4 by blinking 5 times (teal) then blinks once red. When I check it by holding the trigger down it only blinks once for a debounce of 1. Someone who know this chip please help. Thanks

[.:{}:.]

make sure you turn it off after you program it.

[jbuot]

Tried that, but when I turn it on to check the debounce, its still at 1.

[.:{}:.]

when you check the debounce, are you holding the trigger down until it turns teal and then letting go of the trigger before it can shut off?

[shutter_elite]

took me a while to get what your saying? still not sure but might be what i had happen when i first started w/ nox, are like above , are you holding the trigger on the debounce until red changes to like a white?, that is when you input your trigger pulls. from what im reading (could be mistaken) your trying to soon to adjust the setting? sorry if i am off

[jbuot]

When you initially turn on the gun you hold down the trigger for 10 seconds until the white light turns on then turns off. Now you can scroll through the colors depending on what you want to change. Then you hold the trigger down on the color you are trying to change. It allows you to click the trigger the number you want to set it at. Supposedly, you are supposed to hold the trigger down again for 2 seconds to save the setting. But this does not work because once you turn it off and on again, the debounce stays at the same setting.

[p8nt4brainz]

Don't hold the trigger until white unless you want to restore factory default settings. Just hold about two seconds until LED goes out.

Scroll to menu item you want by color and or blinks
hold until LED goes out (two seconds)
min setting will blik, add pulls to increase value
let sit for two seconds, new setting will go in and blink out
turn off marker

Jamie

[jeffreyjames]

i dont have nox so i cant help, but that looks helpful.

[shutter_elite]

like p8nt said, just input your number and let it go, don't have to hold.