A couple Ideas, Id like some feedback on

[hammered]

Im working on picking up a Quest for a Cyborg I have (hopeful) One of the first things I noticed, is the frames are similar in the fact both markers have the little drop in the rear of the frame to accommodate for he solenoid. Im thinking that the frame Ive made (http://community.webshots.com/album/105133958CjGGKQ) (may need to have a couple numbers changed to make it fit a Quest) will cure a few problems. First, I believe useing the new W.A.S. solenoid/micro board combo would help on space saving. With the few rough measurements, Im fairily sure I can fit solenoid/board and battery in the grips. Routing the air shouldnt be an issue with an 90* barb/hose kit from Airsoldier (www.airsoldier.com) Im redesigning the frame to take Intimidator triggers instead of the custom ones I currently have. One of the downsides are the fact that to have the room in the grip, Ill have to make the panels a custom size/shape. If I dont go with the microEQ, I may use the micro Morlock, by all the numbers I can find, it should handle the required power to run the new solenoids. The end result should be roughly 1/2" to 5/8" lower profile.

[dt24]

its definately a lot of steps in the right direction. Two things I would suggest is the option of not having it so angled, maybe have it traditional 45* style. Another one im not sure if it solves already is that the space between the front of the trigger frame and reg mount looks weird. If there could be part of the frame that went up to it it would look better imo.