Trigger on ICON E? How to adjust it?

[RobUpNya]

How do I adjust my trigger pull on my ICON E? I want it closer to the back. Can I do that?

[KrazyDrummer]

nope
:dodgy:

[RobUpNya]

thanks. :confused:

[DJDUCKYI]

you can adjust the pull so that it sits right on the trigger switch.....
just take of the frame and look at the top of the trigger.. should be a screw of some sort.. just adjust it until it sits where you want it.

[RobUpNya]

you can adjust the pull so that it sits right on the trigger switch.....
just take of the frame and look at the top of the trigger.. should be a screw of some sort.. just adjust it until it sits where you want it.

is there anything i have to look out for when i pull the frame off....like is anything going to fall apart or buckle?
any springs going to fly away?

[DJDUCKYI]

NOPE.. just undo the two hex screws that hold the trigger frame to the body.. then look down at the trigger from above... u'll see a small screw.. just screw it in or out.. depending how u want ur trigger to sit... then put it up against the body, and test to see if it is sitting on the switch.... make sure the trigger is not pressing the switch in while u put the frame back onto the body.

[RobUpNya]

thanks DJDUCKYI