Promaster Oring's

[PhattyMcPhatt]

I want to stop at home depot on my way home from work to get some new orings for my Promaster, I mainly need to get some for the lpr piston to see if thats why air is shooting out the hole in my lpr and not to my solenoid to make the hammer cock, so I was wondering if any of you know what size the orings for the piston is. Thanks.

[MajorPaynt]

The hole on the lpr??? Where is it leaking from... the little hole on the housing.. or from the front cap??

[PhattyMcPhatt]

the front of the cap

[gregicd]

www.blueforkdesign.us

[MajorPaynt]

It may be too low now. when i took apart my pm I noticed that it leaks from the front cap when the lpr set screw is set way too low. It (the lpr) then seals when you turn it up a little until finally you get noid leak then have to turn back down. Try screwing the lp adjustment screw in and test the seal every 1/4 turn.

[PhattyMcPhatt]

well I got the cocking/leaking out the front of the lpr thing taken care of now I just need to get that stupid leak that stops when I push the bolt forward to stop, the other thing is I screwed my lpr a ways and no leak came from my noid I finaly stopped turning it in because I didn't want to risk doing anything damaging, I just got to get some loctite for my hammer because I can't get that thing to stay tite, I have a couple ?'s 1st what kind should I get blue or red? What is the difference? and what is the right way to do use it? I've heard major damage can be caused by using it wrong so what is the right way?

[MajorPaynt]

I believe red bonds tighter thatn blue. That would probably be a red loctite job. I'd apply a drop to the threads screw the hammer on and let it sit for a day. Again... I am not a tech.

[KateLover]

http://cgi.ebay.com/ICD-2005-PROMASTER-SLICK-O-RING-KIT-PAINTBALL-HONEY-DOW_W0QQitemZ7181751204QQcategoryZ10554QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem

[TargetIndy]

MarkerKits.com (http://markerkits.com/displayProductDocument.hg?productId=19&categoryId=15)