parts for silver bullet

[paintballr927]

im thinking about buying a silver bullet. Can some one tell me what feedneck to get for it and if the gun uses a hp or lp tank.

[imguessingurgay]

its a ****ty blowback, dont even waste your money on a nitro for this gun, the tank will cost more than the gun,just use CO²....but it will use HP

[paintballr927]

ok works for me, i guess i wont even buy it then.

[imguessingurgay]

good choice :tup:

[neo71665]

I'm not sure on the exact feed neck but they take HP tanks. As a rule of thumb always remember all of your lower end markers use HP tanks. Now for the marker being crappy, its no better and no worse than any other stacked tube blowback that has been massed produced. If you can afford HPA get it. You can always use the tank on anther marker when yo upgrade. Listening to idiots like him we all would still be playing with pumps running 12 grams. Not everybody can go out and spend a few hundred on a starter marker. If your just starting out get ya a marker and a good set of thermal googles. Then a good loader, HPA, and a better marker.

[imguessingurgay]

now, i am saying that, MY silver bullet was a POS, some people might like them, basically the point i was getting at was their are better guns out their than this one, a silver bullet is a spyder clone, the best of the spyder clones are spyders them selves. Now if you want to buy this marker, be my geust. For all i know you may love this gun and not up grade for a year or so. And i belive you can use spyder feednecks, not a 100% sure, but i would think so... And neo was right about low-end guns using HP.

[paintballr927]

i have alot of paintball guns. my friend has a broken silver bullet he is selling for like $35, and i wanted to get it just to mess with. But if its that ****** i guess i wont even bother.

[cote_says]

id get it for that price.

i tried a lapco on it and it didnt fit.

[qhimq]

pychoballistics makes an after market one that is a twist clamping one. but it sucks. i can't fit a halo B unless u sand the halo B. the twist clamping feedneck always gets loose and makes ur hopper fall ne ways. and its just as tall as the stock feedneck.

fix it if u know how. and buy a couple upgrades on it.

u should get a new bolt, cuz that stock silver bullet bolt is super bad. if i was u i'd get a used supafly bolt here at pbnation for $20 or so. unless u want to buy an anti-chop bolt for $40.

u need a 32* (i think 9 piece) spring kit also to make it work good.

tell me if u don't buy it cuz i might buy it, if u don't. i fixed up a silver bullet before and sold it. it was very reliable. 1 chop all day with cheap paint. set at 7bps SEMI with a reloader. what i like about silver bullets is the board. u can adj the cap on it for all the modes of fire.